Counting small plastic components for picking

Counting small plastic components for picking

After production, small plastic components (rings, impellers, etc. ) often does not have the desired surface properties. Unwanted burrs can occur during injection molding or milling, such as: flow lines, heavy burr formation with webbed skin or tinsel burrs. Post-processing the plastic parts can eliminate these problems. After deburring, these small components must be counted for order picking. Manually counting the individual parts is very time-consuming and often error-prone, especially when it comes to large quantities of small parts. The use of a counting scale is recommended here. A counting scale allows for safe and error-minimizing stocktaking or verification in a fraction of the time that would be needed with conventional counting

After deburring small plastic components, they have to be counted for picking. Manually counting the individual parts is very time-consuming and often error-prone, especially when it comes to large quantities of small parts. A counting scale allows for safe and error-minimizing stocktaking or verification in a fraction of the time that would be needed with conventional counting